Professional cleaning tips for removing stains from rubber mat

So you have cleaned your carpet yesterday after much hard work, then bang! It's nothing. Yes, we talk about those pesky little spots of gum.

Nothing like the glorious patches of rubber ditch on a freshly cleaned carpet. In the hustle and bustle of normal daily life, you can not predict when some serious stain annoying rubber may cross his path. But if you do, try not to panic. The point is removable, so you can take appropriate measures at the right time.

In this article we have compiled some of professional carpet cleaning tips on how to best remove stains gum can implement possible. So let's do immediately cast a glance on it.

APPLICATION OF CARPET RUBBER: Method 1

Weather plays an important role in a spot to remove rubber. The sooner you remove it, the better it is. More remains on the carpet, the harder it is for you to remove it.

Anyway, the following tips:

• For ice cubes in a bag, preferably a bag zipper.
• Place the ice pack directly on the stain gum. This hardens the rubber, which makes it easier for you to remove it.
• Use a partial removal tool (shown below in the picture) to remove the side of the rubber mat.

• Gun sponge to the spot directly with a professional cleaning fluid, such as that based on the Formula 409 .
• Cover the stain with a clean towel to absorb excess liquid and continue to maintain until it dries. You can also use a rag to this particular effect of its use.

APPLICATION OF CARPET RUBBER: METHOD 2

Three things are needed for this process, and they are:

• A nail brush,
• A WD-40 (It is the brand for the penetration of water and oil displacement spray)
• A degreaser aerosol or cleaning agent,
• Sponge.

Let us now go through the steps of:

• Spraying a suitable amount of liquid WD-40 directly to the stain gum.
• After the spray applied, let the stain at a time sit for a few minutes.
• (Similar to those shown in the figure below) then remove by using a nail brush for the stain.

source Wiki

Rub point in one direction. Which means that when washing starts left to right, you should this direction possible to maintain prices. No change direction halfway. This will make your carpet is more harm than good in the long run make.

• Application is fluid and WD-40, followed by heavy brush.
• Repeat as necessary.
• Application relating to the area with a detergent or degreaser aerosol directly to the site.
• Get the sponge and rinse with hot water. Apply it on the affected area of ​​the carpet and hold it for a couple of minutes.
• Then clean the area gently until they are no longer visible from the point with the naked eye.

APPLICATION OF CARPET RUBBER: METHOD 3

You will need for this particular method of all hair dryers. So be sure to get one.

hairdryer

Flickr source

Anyway, here are the tips for your reference:

Once you discover the stain on the carpet chewing gum, get your hair dryer and use it directly on the affected area of ​​the carpet.

• Be very careful with your hair dryer. Do not forget the gums too cautious because a little mistake here and a little mistake to see which can melt the carpet fibers.
• Once you see onset of melting gum, use a plastic bag to collect the melted gum place. The molten rubber to the plastic rod when the plastic closure leads.
• Furthermore, in the same manner until the stain is removed from the surface of the carpet.

Note: The time plays an important role in this special cleaning process. The sooner this happens, the better it is.

So that's basically it. It is time to end this now. Hopefully the above tips will be useful to you.

Let you us block the ads! (Why?)