Inverter Battery Maintenance Tips for Better Performance | Your investor can be a miracle in...

If you do not carry out the maintenance of the inverter in time, it can be very serious and even fatal for you and your family later. If you use it properly, the inverter will support you for years and the house electricity bill will also go down. Here are some tips that will keep your inverter in good condition for years.

Required ventilation:

It often happens that the inverter has to be placed in a corner of the house where it is not visible and there is a lack of ventilation, so the inverter heats up due to prolonged use and pressure. and the lack of ventilation can be dangerous for him. In such a situation, keep the inverter in a place with sufficient ventilation. Also remember that in addition to good air circulation, it is also necessary that the place where the inverter is stored is not too hot. If the ventilation is right, your inverter won't make you miserable anytime soon.

Avoid overload:

Each inverter has its own load capacity, number of lamps and fans it can run. But in most cases, people turn on lights and fans excessively, which affects the UPS battery and gradually reduces its performance. In such a situation, use the inverter fan and light if necessary. It also saves electricity and does not damage the inverter.

Also check the battery water level:

The battery is the most important part of the inverter, if the battery is good you will have no problem. In such a situation, checking the battery is also very important. Check the water (acid) level in the battery every two months. Also make sure the water level stays between the maximum and minimum water limits. Always fill the battery with distilled water. Do not use tap water or rainwater as it contains additional minerals and impurities that affect battery life and performance. Remember, if the battery runs out of water, don't ignore it and fill it up quickly. Lack of water will dry out the battery and pose a fire hazard.

Protect the battery from corrosion:

White soot deposits often form on the battery terminals, and rust can sometimes appear in these places. Because the terminals start to get damaged. Corrosion at the terminals reduces the flow of current to and from the battery. This limited current flow slows down the charging of the battery. To clean the terminal, pour a solution of warm water and baking soda on the corrosive area or use a toothbrush to clean. The war will pass. Remember not to put petroleum jelly or petroleum jelly on the terminals as this can damage the battery.

Also Read: Whether you are young or approaching old age, you will also learn about this Garmin fitness band

Also pay attention to the wiring:

Also ensure that the inverter cable is secure and not loose as a loose cable can cause a short circuit and cause a fire in the cable or inverter. Therefore, the wiring must be kept tight after some time.

Try Adblock (Why?)